Register Your Details

The No 1 Internal Corner Bracket is made from a toughened alloy and is particularly suitable for forming square back frames for various shapes of wet look blinds and the base for approach awnings and
Type J Blinds. 

French Awning Bracket 45 Degrees A new sturdy component to the range is the Fab 45 which enables the Awning manufacturer to fix the mitred edges to the back and base frame on both sides of the extrusion giving a neater and stronger fixing than pieces of aluminium angle. 

Note the classic clean lines of this French Awning using the renowned No 1 System: 2 Fixed Awning Brackets, 4 Mitre Corner Brackets and of course 8 French Awning 45 degree Brackets. 







  

The Fixed Awning Bracket Designed to improve the manufacture of French type awnings, fixed radius Dutch and Approach Awnings. It is made from a robust alloy and enables the fitter to drill through the bracket into the masonry without the chuck of the drill marking the extrusion. Available for both No1 & No 2 extrusions. 

The Centre Leg Bracket, at last one that does not require cutting the top rail. Fit your centre leg on site, get into the exact position that is required, two pre-drilled holes in the bracket act as drill guides avoiding the possible mishap of the drill going through the cover. Available for both No 1 & No 2 extrusions. 

The problem of unsightly open ends of extrusion has also been solved. Fab 45 has been designed so that it covers the mitred Aluminium thus giving a neat and professional finish to the Awning. 
 

The AAMCB allows the 2”x1.5” heavy duty base to be mitred when joining the projection to the width. The special feature of this new component is the raised nose which prevents wear on the corners of the Valance as a result of movement in the wind. 
 

The Fixed Intermediate Bracket. We supply it with all our type J Fixed Radius Awnings and Type F Dutch caps also Approach Awnings Type K and M Kits. It will do away with the bending of Aluminium Ribbing or Nylon Hinges to hold the bends in position. These brackets are extremely strong and will enable the blind maker to cut down on ribbing. The bracket has a slot to the side, which allows the PVC insert to sit on the bottom extrusion. This gives you fastening of the fabric all
the way.

Available for both No1 & No 2 extrusions. 

The AABWB enables sub­stantial fixing of the frame work to the wall. The special feature of this component is the staggered fixing holes which helps prevent twisting of the Approach Awning during high winds. 

  

Approach Awning Heavy Duty Base When fixing an Approach Awning it is strongly recommended that a heavy duty base is used to avoid possible damage to the framework due to gale force winds and vandalism. However, we have now developed two new components which ensure that the fixing of the base frame is easier and more efficient, as well as providing a more professional finish. 

SOB 1&2 Stand Off Brackets will fit into your extrusion off cuts, save all the expense of tailor made brackets in the factory and invariably arriving on site too large or too small, more often than not left behind in the works by the fitter or forgotten altogether by the rep! All that is now required is a handful of stand off brackets,several lengths of off cuts and you can be sure of a perfect fit for your stand off brackets every time. Available for No 1 and No 2 extrusions.